I know the issue has been followed in another thread, but I think my question is more appropriate here.
@micmalti Could you please tell me whether you had to disable hardware write protection using the CR50 jumper method? If so, could you please hint me at where you learned how to do it?
After reading the page about Firmware Utility Script I was under the impression that enabling UEFI boot can be achieved without touching the hardware, yet reading the firmware write protect page suggested me otherwise. From the other thread I know you didn’t yet have the SuzyQ cable at the install time, so you must have used the CR50 jumper method or haven’t touched the hardware at all. I will appreciate any guidance.